COMMERCIAL ITEM DESCRIPTION A-A-51303
Pneumatic test: Ten psig pressures applied for one minute. The needle cannula shall not pull out of, or loosen from, the needle hub when subjected to an axial force of ten pounds.
Precautionary statement. A caution note shall appear on the label that shall state the following “Once needle is withdrawn do not reinsert into catheter” (or similar wording).
Instructions. Instructions for use shall be provided in each unit package.
Workmanship. The catheter and needle shall be free from defects which detract from its appearance or impair its serviceability.
Unit.Package (PG). One package containing fifty individually packaged catheter and needle units, each unit individually packaged in a container capable of maintaining sterility of contents unless package is damaged or opened, as specified, constitutes one unit.
Quality Assurance Provisions.
Responsibility for inspection. Unless otherwise specified in the contract or purchase order, the contractor is responsible for the performance of all inspection requirements as specified herein. Except as otherwise specified in the contact or purchase order, the contractor may use his own or any facilities suitable for the performance of the inspection requirements specified herein, unless disapproved by the Government. The Government reserves the right to perform any of the inspections set forth in the specification where such inspections are deemed necessary to assure supplies and services conform to prescribed requirements.
Records. Records of examinations and tests performed by or for the contractor shall be maintained by the contractor and made available to the Government upon the Government’s request, at any time, or from time to time, during the performance of the contract and for a period of three years after delivery of the supplies to which such records relate.
Inspection. Inspection, as used herein, is defined as both examination (such as visual or auditory investigation without the use of special laboratory appliances or procedures) and testing (determination by technical means of physical and chemical properties) of the item.
Tests. Tests shall be conducted to determine compliance with specification requirements. Where feasible, the same sample shall be used for the determination of two or more inspection characteristics.
Sampling for tests. Sampling for tests shall be conducted in accordance with MIL-STD-105 and as specified herein. The unit of product for test purposes shall be one package of catheter and needle units.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business