COMMERCIAL ITEM DESCRIPTION A-A-51763
Sizes. Cannulae shall be of the following sizes, as specified.
|
Type |
Size (gage) |
|
1 |
14 |
|
2 |
16 |
|
3 |
17 |
|
4 |
20 |
|
5 |
22 |
|
6 |
24 |
Workmanship. The cannula shall be free from defects which detract from its appearance or impair its serviceability. The surface of the cannula shall be smooth and the lumen void of obstructions.
Unit. Each (EA). One cannula, of the size specified, constitutes one unit.
Quality Assurance Provisions.
Responsibility for inspection. Unless otherwise specified in the contract or purchase order, the contractor is responsible for the performance of all inspection requirements as specified herein. Except as otherwise specified in the contact or purchase order, the contractor may use his own or any facilities suitable for the performance of the inspection requirements specified herein, unless disapproved by the Government. The Government reserves the right to perform any of the inspections set forth in the specification where such inspections are deemed necessary to assure supplies and services conform to prescribed requirements.
Records. Records of examinations and tests performed by or for the contractor shall be maintained by the contractor and made available to the Government upon the Government’s request, at any time, or from time to time, during the performance of the contract and for a period of three years after delivery of the supplies to which such records relate.
Inspection. Inspection, as used herein, is defined as both examination (such as visual or auditory investigation without the use of special laboratory appliances or procedures) and testing (determination by technical means of physical and chemical properties) of the item.
Tests. Tests shall be conducted to determine compliance with specification requirements. Where feasible, the same sample shall be used for the determination of two or more test characteristics. The Luer fitting shall be tested for dimensions and performance in accordance with ANSI/HIMA MD70.1. the cannula shall be tested for hardness in accordance with ASTM E18 or ASTM E92 and E140.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business